Summit SPW1103ADA User Manual
Page 18
188635
•
By the user
Selecting Pump stop function
Program is stopped when it comes to the ‘PUMP
STOP’ stage (if this function had been previously
selected). Drum door remains closed all the time.
Indicator LED above the ‘Pump stop’ function
starts flashing. Washing procedure is continued by
pressing the START knob (C).
Own (physical) interruption
You may also stop the program by turning the
program selector to the position “0”. If there is
water in the drum select one of additional programs
(draining, spinning) to empty the water and
terminate the program.
Pause button
By pressing the PAUSE button, (C) the program
may be suspended at any time. After certain time
you may open the door if there is no water in the
drum, otherwise this is not possible. Program is
continued by pressing the START button (C).
•
Failures
Program is suspended in case a failure occurs.
Signal LED’s are flashing (see Troubleshooting).
•
Power failure
At electric cutout the program is interrupted,
however, after the power supply has been re-
established, the program operation automatically
proceeds.
If a power failure occurs when the drum is
still full of water, be careful not to open the
door before you drain the water out.
18
Interruptions