Summit SPW1103ADA - Manual (Page 9)

188635
•
Level the appliance by turning the adjustable legs.
Placing a “bubble” level on the washer may assist
you.
The legs are adjustable up to +/- 0,39 inch (1 cm).
After the adjustment tighten the nuts firmly (A)
- towards the bottom of the machine!
The floor must be a hard surface with a
maximum slope of ½˝ per foot (1,27 cm per 30
cm). To make sure the washer does not vibrate
or move, you may have to reinforce the floor.
The appliance should be placed on a surface
with concrete base; the surface should be
dry and clean in order to prevent slipping.
The adjustable feet should also be cleaned
before installation.
•
If you have a tumble dryer of the same
dimensions, you can place it on top of the
washing machine.
To ensure correct operation of the appliance,
inlet water pressure must be between 7 psi to
116 psi (0,05 MPa and 0,8 MPa).
Minimum water pressure can be established by
measuring the quantity of poured out water.
0,8 gal (3 litres) of water must be poured out
from a completely opened tap in 15 seconds.
•
Take the water inlet hose from the drum and
attach the inlet hose angle extension (1) to the
washing machine by screwing it onto the provided
thread (certain models only).
•
Insert the gasket with a filter net into the straight
inlet hose attachment nut () and screw the nut
9
Water inlet connection
Leveling the appliance