Talos Security DR800 Series DVR User Manual - Manual (Page 18)

H.264 Network DVR
- 18 -
Figure 3-3
Incorrect Shut Down:
A. Avoid turning off the master POWER switch on the rear panel.
While the DVR is running, you can shut it down immediately by the power switch on the rear panel; avoid this (especially while recording).
B. Avoid unplugging the power cable.
While the DVR is running, you can shut it down immediately by unplugging the power cable; avoid this (especially while recording).
Note: If the power supply is not functioning properly, please contact your dealer for a replacement. Only replace with a compatible
regulated power supply to avoid any incidental damage.
3.2 Login
There are three default users in the system, they are "admin", "user", "default", the users of the system can not be removed. The initial password for
user "admin" is 666666; this is the highest authority user and enables out all system operations. The initial password of user "user" is 123456; this
user level can record, playback, backup and set parameters, etc., but cannot add new users or make changes in the system. The user “default” is set
at the factory, it has the lowest authority level; only monitoring capability. (Figure 3-4)
Figure 3-4
Password security measures: A user can only attempt five times in every 30 minute period to access the system, otherwise the account will be locked.
Note: For security reasons, please change the default password during initial setup. To add and modify users, please refer "User Management"
section.
NOTE: While the DVR is recording, timed recording or alarm recording, and power is lost or the DVR has a forced to shutdown, the DVR
will preserver the videos and automatically return to the prior operating condition.