Talos Security DR800 Series DVR User Manual - Manual (Page 42)

H.264 Network DVR
- 42 -
6.3 Recording Setup
"Main Menu" - "System" - "Recording Setup" (Figure 6-4)
The DVR default recording mode is 24 hours continuously. The DVR recording mode can be set to meet the users' application.
Figure 6-4
"Disk Full" There are two options when the DVR hard drive is full; “Over write” the oldest files and continue to record and “Stop Video recording”.
"Duration" Set the maximum time an event will record to a file between 5 and 120 minutes.
"Channel/Schedule" Drop-down menus. Select the corresponding channel number and day to schedule recording. Click “ALL” to choose all channels.
"Alarm Pre-Record" Saves the five seconds of video prior to the alarm event to the file.
"Time Section" Select the scheduled record time for each channel, there are four time options. The time scope is 00:00-24:00. After each channel
parameter is set press the "Save" key.
"Normal, Motion, Alarm" Setup the record mode for each channel; selection can be single or multi-selection.
"Copy Setting To The Following Channel" Copy the setup to all channels.
Note: Select save after setting each channel.