4 maintenance, 1 cleaning, Maintenance – Ultralife CH0007 User Manual
Page 19: Leaning, Igure, Harger lid tightening screw
CH0007 Operation Manual
Newark, New York | 315-332-7100 | Fax: 315-331-7800
©2010 Ultralife Corporation • www.ultralifecorp.com • All specific subject to change without notice
The information contained herein is for reference only and does not constitute a warrant of performance •
30 SEP 10 UBI-5166 Rev: A
Page 19 of 25
4 MAINTENANCE
Maintenance for the CH0007 is described in the following sections.
4.1 Cleaning
The charger exterior and control panel can be cleaned with mild detergent. Use non-abrasive
cleaning supplies for this purpose.
Care should be taken when cleaning the battery cavities to prevent damage to charge pins.
Avoid fluid seepage into battery cavities during cleaning.
Allow charger to fully dry before use.
Periodically tighten the lid hinge tension screw. This will ensure that the lid hinges remain taut.
Location of this screw is shown in the Fig. 12 below.
Figure 9: Charger lid tightening screw
Tighten this screw to ensure lid
remains taut.