2 exterior – rear view, Exterior – rear view, Igure – Ultralife CH0007 User Manual
Page 9: Ch0007
CH0007 Operation Manual
Newark, New York | 315-332-7100 | Fax: 315-331-7800
©2010 Ultralife Corporation • www.ultralifecorp.com • All specific subject to change without notice
The information contained herein is for reference only and does not constitute a warrant of performance •
30 SEP 10 UBI-5166 Rev: A
Page 9 of 25
2.1.2 Exterior – Rear View
Figure 2: CH0007 Rear View
(A)
Charger Body – The charger body is made from aluminum.
(B)
Charger Lid – The charger lid is made from aluminum.
(C) Charger Lid View Ports – Several areas of the charger lid have polycarbonate label- covered
windows for viewing the status of the charger without having to open the lid.
(D)
Lid Latches – Metal push button-style latches secure the lid tightly to the base.
(E)
USB Input Connector – Round circular connector that houses a USB input socket. This connector
should be protected by a screw-on cap when not in use. (Cap is provided and attached using chain)
(F)
Power Connector – Circular connector that houses the power socket. This connection should be
protected by a screw on cap when not in use (cap is provided and attached using chain)
(G) Pressure Release vent – Watertight pressure release vent helps balance internal pressure of
charger case.
(H)
Lid Hinge – Attaches lid assembly to the main charger body.
(I)
Mounting Bracket – Mounting brackets are integrated to the rear face of the charger main body.
These brackets provide easy mounting to a vehicle/rack.
(J)
Heat Sink – A machined heat sink is integrated to the rear face of the charger. The heat sink
facilitates easy heat dissipation during charging/conditioning cycles.