Configure the module, Uninstall the removable terminal block (rtb) – Rockwell Automation 1756-RIO ControlLogix Remote I/O (RIO) Communication Interface Module Installation Instr User Manual
Page 22
Advertising
22 ControlLogix Remote I/O (RIO) Module
Rockwell Automation Publication 1756-IN610B-EN-P - November 2010
Configure the Module
Once installed, your 1756-RIO module must be configured. Refer to the
1756-RIO user manual, publication
configuration.
Uninstall the Removable Terminal Block (RTB)
To remove the RTB, grasp firmly and pull out.
WARNING: If you connect or disconnect the communication cable
with power applied to this module or any device on the network, an
electrical arc can occur. This could cause an explosion in hazardous
location installations. Be sure that power is removed or the area is
nonhazardous before proceeding.
44776
1
2
Advertising