Rockwell Automation 1738-IT2IM12 ArmorPoint RTD and Thermocouple Modules, Series A - Manual (Page 6)

6 ArmorPOINT RTD and Thermocouple Input Modules
Publication 1738-IN005B-EN-E - January 2013
Install the Module
Follow the instructions to install the ArmorPOINT input module.
1. Using a bladed screwdriver, rotate the keyswitch on the mounting base clockwise
until the number 6 aligns with the notch in the base.
2. Position the module vertically above the mounting base. The module bridges
two bases.
3. Push the module down until it engages the latching mechanism. You hear a
clicking sound when the module is properly engaged. The locking mechanism
locks the module to the base.
Remove the Module from the Mounting Base
Follow the instructions to remove the module from the mounting base.
1. Insert a flat blade screwdriver into the slot of the orange latching mechanism.
2. Push the screwdriver toward the I/O module to disengage the latch. The module
lifts up off the base.
3. Pull the module off the base.
MOD
NET
1738-IR2M12/A
RTD (Ohms) In
0 1
RTD 1
RTD 0
Module bridges two bases.
43782