Baracoda BCM 2604 - Manual (Page 14)

3 Symbologies
This programming section contains the following menu selections
Linear barcodes
Codabar, Code 39, Interleaved 2 of 5, Code 93, EAN, Code 2 of 5, IATA Code 2 of 5, Matrix 2 of
5, Code 11, Code 128, Telepen, UPC A, UPC-A/EAN-13 with Extended Coupon Code, EAN/JAN
13, EAN/JAN 8, MSI, Plessey Code, RSS-14, RSS Limited, RSS Expanded, PosiCode A and B
Stacked barcodes
Code49, Code 16K, PDF417, Macro PDF417, Micro PDf417, EAN/UCC composite codes, RSS
stacked and composite, Trioptic, TLC39, Codablock F
Postal Barcodes
Postnet, Planet Code, British Post, Canadian Post, Kix (Netherlands)Post, Australian Post, Japanese
Post, China Post, Korea Post,
2D Barcodes
QR Code, DataMatrix, MaxiCode, Aztec Code
3.1 Reset all parameters
The reading of the "Default settings” label turns all the parameters back to default settings:
3.2 All Symbologies On and Off
If you want to decode all the symbologies allowable for your imager, scan the All Symbologies On
code. If on the other hand, you want to decode only a particular symbology, scan All Symbologies Off
followed by the On symbol for that particular symbology.
3.3 Message Length Description
You are able to set the valid reading length of some of the bar code symbologies. If the data length of
the scanned bar code doesn’t match the valid reading length, the imager will issue an error beep.
You may wish to set the same value for minimum and maximum length to force the imager to read
fixed length bar code data. This helps reduce the chances of a misread.
13
All Symbologies On
All Symbologies Off