Baracoda BCM 2604 - Manual (Page 25)

Original Telepen Output
3.13.2 Telepen Message Length
Scan the bar codes below to change the message length. Refer to Message Length Description
(chapt 3.2) for additional information. Minimum and Maximum lengths = 1-60. Minimum Default = 1,
Maximum Default = 60.
3.14 UPC A
Default All UPC-A Settings
UPC A
3.14.1 UPC-A Check Digit
This selection allows you to specify whether the check digit should be transmitted at the end of the
scanned data or not. Default = On.
3.14.2 UPC-A Number System
The numeric system digit of a U.P.C. symbol is normally transmitted at the beginning of the scanned
data, but the unit can be programmed so it will not transmit it. Default = On.
24
* On
Minimum Message Length
Maximum Message Length
* On
Off