Baracoda BCM 2604 - Manual (Page 17)

Maximum Default = 60.
3.5 Code 39
< Default All Code 39 Settings >
3.5.1 Code 39 Start/Stop Characters
Start/Stop characters identify the leading and trailing ends of the bar code. You may either transmit,
or not transmit Start/Stop characters. Default = Don’t Transmit
3.5.2 Code 39 Check Character
No Check Character indicates that the imager reads and transmits bar code data with or without a
check character.
When Check Character is set to Validate, but Don’t Transmit, the unit only reads Code 39 bar codes
printed with a check character, but will not transmit the check character with the scanned data.
When Check Character is set to Validate and Transmit, the imager only reads Code 39 bar codes
printed with a check character, and will transmit this character at the end of the scanned data. Default
= No Check Character.
16
Validate, but Don’t Transmit
* No Check Character
Validate and Transmit
Minimum Message Length
Maximum Message Length