Baracoda BCM 2604 - Manual (Page 28)

3.14.12 UPC-E0 Number System
The numeric system digit of a U.P.C. symbol is normally transmitted at the beginning of the scanned
data, but the unit can be programmed so it will not transmit it. Default = On.
3.14.13 UPC-E0 Addenda
This selection adds 2 or 5 digits to the end of all scanned UPC-E data. Default = Off for both 2 Digit
and 5 Digit Addenda.
3.14.14 UPC-E1
Most U.P.C. bar codes lead with the 0 number system. For these codes, use UPC-E0. If you need to
read codes that lead with the 1 number system, use the UPC-E1 selection. Default = Off.
EAN/JAN-13
<Default All EAN/JAN Settings>
3.15 EAN/JAN-13
Off
27
Off
* On
* 5 Digit Addenda Off
5 Digit Addenda On
* 2 Digit Addenda Off
2 Digit Addenda On
UPC E1 On
* UPC E1 Off