Removal and insertion under power, Make the ethernet connection, Wire the ethernet connector – Rockwell Automation 1756-NEX Nexus Module User Manual
Page 24: Removal and insertion under power -4, Make the ethernet connection -4, Wire the ethernet connector -4
Advertising
2-4 Install the 1756-CLX/C Module
Publication 1756-UM524B-EN-P - December 2008
Removal and Insertion under Power
Make the Ethernet Connection
Wire the Ethernet Connector
The 1756-CLX/C module has an Ethernet port you will use to connect to the NeXUS
network. Use an RJ45 connector to connect to the Ethernet network. Wire the appropriate
connector as shown below:
For detailed connnection information, refer to the EtherNet/IP Media Planning and
Installation Guide, publication ENET-IN001A-EN-P.
WARNING
We do not recommend that you install or remove the module under
power.
1 ------ TD+
2 ------ TD-
3 ------ RD+
4 ------ NC
5 ------ NC
6 ------ RD-
7 ------ NC
8 ------ NC
RJ 45
8
1
Advertising