Rockwell Automation 2706-DXX Dataliner Message Display DL5 Series - Manual (Page 43)

2706-UM001A-US-P
Chapter
5
Run Mode
Chapter Objectives This chapter describes how to enter and exit run mode. You will also learn
how the DL5 operates while in run mode.
Entering Run Mode Run Mode - Parallel Operation
To enter run mode for parallel operation:
1. Make sure the Serial Trigger / Configure DIP switch (SW1-1) is in the
DOWN (Configure) position.
2. Check that the following prompt is displayed:
Note: To get the RUN? prompt from the Special Functions Mode, press
[Esc] three times. From the Edit Mode, it is also necessary to answer no
to Edit? and Special Functions?
3. Press the [Y] and [Retrn] keys to enter the run mode. The DL5 will
display either a blank screen or a selected autorun message. Chapter 8
describes the autorun message and how the autorun message is selected.
The DL5 is now in the run mode and will display any messages that are
triggered by the control system.
To exit the parallel run mode:
Press the [Esc] key three times. The DL5 displays the following prompt
when run mode is terminated:
1 2
DOWN
Configure
Not Used
SW1
RUN?
RUN?