BBE DS48 - Manual (Page 30)

24
CREATING A PROGRAM
®
Once the device type and crossover type have been selected, the main
screen will show blocks for each programmable section. This is referred to
as the “Flow Chart”. The term “program” is used here as an equivalent to
“preset” or “configuration” as used on other programmable devices.
Clicking on any box in the “flow chart” other than the Input Gain or Source
will display the Device Window. This window has tabs at the top that pro-
vide access to all the other windows for various functions. Each function
window may in turn have additional windows. Simply click on the tab for
the desired function. If it is not the one that the window was opened under.
Example: Click on X-over for channel A. If Output 1 is assigned to Channel
A, then the crossover screen for Out-1 will appear with the Out-1 tab high-
lighted. Now if you want to set a delay for that output, just click on the
Delay tab and the Delays window will open.
Clicking on any of the Input Gain boxes (label In-A, In-B, etc.) or Source
boxes will open the Input Signal Selection Window.