Autocue QMaster Complex - Manual (Page 34)

QMaster Comple Language-UserGuide.docx 2012-10-02
34
© 2003-2011 Autocue Group Ltd.
The Centre Stop Mode is a setting that allows you to control the direction and speed of the scrolling text using the
knurled wheel. As the wheel passes the designated stop point, the movement of the text will slow down and then
change direction.

To enable this feature, select the Centre Stop Mode box.
Stop Point
To select a Stop Point, enter a value in the Stop Point field. This is a point during the turn of the scroll wheel where
scrolling stops. Values range from 0 to 63. By default, the value is 63, which corresponds to a position
approximately half way around the movement of the scroll wheel.
The value you select depends upon your needs as an operator. If you are an operator who is likely to be moving
backwards and forwards in the same script such as during a rehearsal, or is making last-minute changes, you might
want to set a lower Stop Point value. On the other hand, if you are an operator that is likely to be scrolling
continuously, and is less likely to be moving backwards and forwards in a script, you may consider setting a higher
Stop Point value.
Button actions
Each of the 12 buttons on the controller can have an action assigned to it.
1. Click the Buttons tab.
In this menu you can configure the function for the 12 buttons of the controller.
2. Click on a button and the action currently assigned to it is displayed in the Button
Function field.
3. Click the arrow at the end of the field to display the list of available functions.
4. Choose a function or action for the button from the list.
Note: Once a button function has been chosen, that function will not be available to assign to
any other button.
Scroll rates