Autocue QMaster Complex - Manual (Page 6)

QMaster Comple Language-UserGuide.docx 2012-10-02
6
© 2003-2011 Autocue Group Ltd.
Click Next to continue. Various messages are displayed indicating that the installation is
in progress and the QMaster files are being copied, extracted and downloaded from the
CD.
When the installation is complete, a message is displayed indicating successful setup.
Click OK.
You should now follow the steps to “Prepare and connect to your QBox” before running the QMaster software.
Prepare and connect to your QBox
Attach either a USB keyboard to your QBox so that you can access the configuration and information windows.
Attach a teleprompter
A QBox has both composite and VGA signal outputs. When QBoxes are shipped they are configured to use the
composite video output (BNC connection). The video format is set to NTSC when shipped to the Americas and to
PAL when shipped to other regions of the world.
Configure your network connection
After connecting your QBox to your computer via an Ethernet switch you must configure the Ethernet port on the
rear of the unit. This port is referenced as lan0 by the QBox firmware.
(You may need to refer to your IT support team to get the IP configuration details you need to use.)
Press the F8 key on the QBox keyboard to bring up the configuration menu.
1. Use the Down arrow key to select Configure QBox and then press Enter.
2. Press the Down arrow to highlight Network Configuration and press Enter.