Set up your television – Bang & Olufsen BeoVision Avant - User Guide User Manual
Page 11
11
Set up your television
Set the maximum angle the TV will turn on
the motorised floor stand or wall bracket.
Remember to leave enough space around
the TV to allow it to turn freely. If your
television is mounted on the motorised
table stand, it can be slightly tilted to avoid
disturbing reflections. For more
information,
If the television is to be moved when
mounted on the floor stand, it must be
dismounted. Also, it is important that the
stand is set in TRANSPORT mode. When
placed in a new position, the stand must be
set up again. Bring up SETUP then STAND
to set it up again.
The TV has several placement options. Refer
for available
stands and wall brackets or contact your
Bang & Olufsen retailer. Depending on your
television size different stands are available.
Due to the weight of the TV, any moving or
lifting of the TV should be performed by
qualified personnel – using the proper
equipment.
Placement options
The television must be set up by
qualified service personnel
according to the guide for the
stand or bracket. The television
has several placement options.
Guidelines for placement and
connection must be followed.
To ensure proper ventilation, allow
enough space around the screen. At
over heating (flashing standby indicator
and an on-screen warning), switch the
TV to standby, not disconnected from
the mains, in order for the TV to cool
down. You cannot operate the TV during
this time.
WARNING! Do not lift or otherwise move
your television physically when it is
mounted on the floor stand. It could
cause the television screen to break.
Contact your retailer.
If your television is mounted on the table
stand, make sure it is placed on a table
that can handle the heavy weight of the
television and the table stand.
Wall bracket and stands
Handling
The TV is not designed to stand on its own.
It must be supported until mounted. To
prevent injury, use Bang & Olufsen
approved brackets or stands only!