Record a programme, When it is broadcasted. bring up a list of, Timers to edit a timer or to get an overview – Bang & Olufsen BeoVision Avant - User Guide User Manual
Page 35
35
Record a programme
A connected USB HDD or SSD set
up for recording allows you to make
Timer recordings and execute two
Timers simultaneously. Your stored
Timers are listed in the TIMER
INDEX. Here you can edit or delete
your Timers.
You can also copy a programme
from the timeshift buffer to the USB
HDD or SSD to keep it.
To ensure that your Timers are
executed correctly, set the built-in
clock to the correct time and date.
The menus enabled for the USB
HDD or SSD set up for recording
offer options for settings and
adjustments. Bring up the
RECORDING SETTINGS menu and
follow on-screen instructions. Also
press INFO to bring up help texts.
For information about USB HDDs or
SSDs,
It is only possible to record from digital
channels.
Recording on a USB HDD or SSD may not be
supported by all programme providers.
You cannot record a programme from a radio
station.
In some countries, it is not possible to record
a CI+ programme while watching another
programme.
Make a Timer recording
Set a Timer in the TIMER PROGRAMMING
menu. Here you select the source to be
recorded, the programme’s start time, the
stop time and the date or days of the week
that the programme is shown.
To set a Timer, bring up the TIMER
PROGRAMMING menu.
You can record from one of the television
tuners while playing a recording. You can
also record a programme to the hard disk
and at the same time save a programme to
the timeshift buffer. There are some
limitations regarding recording and
timeshift. For more information, see the
following pages and
You can also start to play a recorded
programme even though recording of the
specific programme is still in progress. Note
that you cannot record copy-protected
programmes. For information about making
a manual recording here and now,
.
KEEP EPISODES is only available when DATE
is set to WEEKDAYS and PROTECTION is set
to OFF.
If the Timer index is full, the TIMER
PROGRAMMING menu is inaccessible.
If a Timer recording, for some reason, is not
successfully completed, you are notified if
the same programme is found in the
Programme Guide for you to make a new
Timer.
If a Timer recording is programmed from the
Programme Guide or the information display,
it is only possible to change the protection,
category and parental lock status.
If a recorded programme is split into two
events, for example, due to a news
programme, both events are recorded.
However, this requires that there is less than
three hours between the start and stop time
of the recordings and that the Programme
Guide recognises that the two programmes
are related.
MENU
RECORDINGS
TIMER PROGRAMMING
Continues …