Daily use of sound modes and speaker groups – Bang & Olufsen BeoVision Avant - User Guide User Manual
Page 47
47
Daily use of sound modes and speaker groups
You can extend your television
into a surround sound system by
adding BeoLab loudspeakers
and subwoofers.
When you switch on one of the
sources, the television
automatically selects the
appropriate sound mode for the
source you are using. However,
you can select another sound
mode at any time.
Also when you switch on the
television, the TV speaker group
is selected automatically.
However, you can always select
another group of activated
speakers if you want to listen to
music without having to sit in
front of the television, for
example, when you sit at the
dining table or in an armchair.
You can adjust the settings of the sound
modes and set up speaker groups. For
information about setting up sound
modes and creating speaker groups,
You can select the sound mode that suits
the source you are using.
To select a sound mode …
Press to bring up SOUND in the
BeoRemote One display
Press to select the sound mode
you want
Step between modes
Press to remove SOUND from
the display
Select a sound mode
Select a speaker group
Select the speaker group that suits your
listening position.
To select a speaker group …
Press to bring up SPEAKER in
the BeoRemote One display
Press to select the speaker
group you want. The selected
speakers cut in automatically
Step between groups
Press to remove SPEAKER
from the display
When you configure a source, you can set
both a sound mode and a speaker group to
be selected automatically each time you
switch on the source. The settings are made
in the ADVANCED SETTINGS menu which is
found when you highlight a source and press
the
red button in the SOURCE LIST menu. If
the source is not in the SOURCE LIST, press
the green button to find the source first.
LIST
SOUND
1 – 9
BACK
LIST
SPEAKER
1 – 9
BACK