Bang & Olufsen BeoVision Avant - User Guide - Manual (Page 19)

19
To operate non-Bang & Olufsen products
with a BeoRemote One or the BeoRemote
App, attach a Bang & Olufsen IR-transmitter
on your non-Bang & Olufsen product and
then connect it to one of the sockets
marked PUC on the connection panel.
Attach the transmitter near the IR-receiver
on the connected equipment to ensure
remote control operation. Before attaching
the transmitter permanently, check that you
can operate the equipment menus on the
television screen using BeoRemote One or
BeoRemote App.
When you set up the transmitter to a
selected PUC socket in the SOURCE LIST
menu, settings for the IR-transmitter are
made automatically. However, it is possible
to perform a manual setup of the socket if
alternative settings are required.
For an extra PUC cable, contact your Bang &
Olufsen retailer.
For information about download of
Peripheral Unit Controller (PUC) tables for
set-top boxes,
see page 23 .
>> Connections
If you want to watch coded channels,
contact your service provider. The service
provider will register you as an authorised
viewer, usually requiring payment. You will
then be provided with a Smart Card and a
CA Module. Note that these will only be
valid for one service provider and therefore
only work with certain channels.
The CA module is a ‘card reader’ for your
Smart Card which decodes the coded
signals sent out by the service provider.
Only uncoded digital channels, also known
as ‘free-to-air’ channels, are available
without Smart Cards and CA Modules.
Contact your Bang & Olufsen retailer for
information about compatible CA Modules.
The Smart Cards must remain in the CA
Modules, unless your service provider asks
you to remove it. This is important in case
your service provider wishes to send new
information to your Smart Card.
Insert a Smart Card carefully into a CA
Module. The CA Module has one protruding
edge on one side and two protruding edges
on the other side. If the television does not
receive any signal, check that the Smart Card
and CA Modules are inserted correctly.
Smart Cards and CA Modules may also give
access to special menus which are not
described here. If this is the case, follow the
instructions from your service provider.
Smart Card for digital channels
IR-transmitters
COMMON INTERF
ACE
CHIPSIDE CHIPSIDE
Continues …