Switching an i/port, Switching an i/port to another blade, Figure 31 – ClearCube Grid Center Admin Guide 4.11 User Manual
Page 59: Selecting a blade, Figure 32, Confirm dialog for switching
Grid Center 4.11 Administrator’s Guide
Switching and Sparing • 53
Switching an I/Port
Switching an I/Port is possible only when the I/Port user has already connected to a
Blade using the Grid Center I/Port client.
Switching an I/Port to Another Blade
1. Select the I/Port to be switched from the left pane. The I/Port description at the
bottom shows the user name and the Blade to which it is currently connected.
2. Using the Blade Group menu, select the Blade group containing the Blade you
want connected to the selected I/Port. Click on the target Blade in the right
pane. The Blade description at the bottom shows the name of the I/Ports that
are connected to that Blade.
3. Click the Switch button to switch the I/Port to the selected Blade. If other
I/Ports are already connected to the Blade, the following screen is shown:
Clicking on Disconnect All disconnects all the currently connected I/Ports, and then
connects the selected I/Port to the Blade. Clicking the Connect This button connects
the selected I/Port to the Blade while leaving all other I/Port connections intact.
Figure 31 Selecting a Blade
Figure 32 Confirm Dialog for Switching