DJI Lightbridge User Manual User Manual
Page 22
©2014 DJI. All Rights Reserved.
22
the air system. When using camera that has HDMI output, connect HDMI output from the camera to the HDMI
input port on the air system. It is possible to control air craft and gimbal using single remote control, as long as
proper channel mapping is completed in DJI LIGHTBRIDGE Assistant. It is also possible to control the gimbal
independently with a 5.8GHz receiver, in this scenario, it is required to connect the 5.8GHz receiver to the AUX2
port on the DJI gimbal.
Scenario 5 – DJI non-HD gimbal with 5.8GHz receiver
1.
Connect either HDMI or AV port on the air system to the HDMI or AV port according to the choice
of the camera.
2.
Connect Gimbal Port to onboard battery and CAN-bus port on DJI flight control system (CAN1 port
for DJI A2 users) via the supplied air system power and CAN cable.
3.
Connect DBUS to DBUS port (X2 port) on flight control system with DBUS cable.
4.
Connect 5.8GHz receiver to the AUX2 port on the DJI non-HD gimbal GCU, when using 5.8GHz
receiver to control the gimbal.
5.
Refer to gimbal and flight control system manuals to complete connection.
Below example is based on DJI Z15-5D gimbal and A2 flight control system with 5.8GHz receiver.
6.
A CAN-Hub or iOSD Mark II is required to provide extra CAN ports, if there is not enough CAN
port.
Scenario 6 – DJI non-HD gimbal with Single Remote Control
It is possible to control both aircraft and gimbal with single remote control as long as proper channel
mappings is completed through DJI LIGHTBRIDGE Assistant. Follow the instructions below to complete the
Devices on
CAN1 BUS
OR