DJI Lightbridge User Manual - Manual (Page 48)

©2014 DJI. All Rights Reserved. 48
Manufacturer Model Connect Type Maximum Gain Impedance
INVAX System Technology Corp. AN2400-
06169GMX
MMCX Male 2.7 dBi 50 Ohm
Ground system
This radio transmitter (11805A-201402241) has been approved by Industry Canada to operate with the antenna
types listed below with the maximum permissible gain and required antenna impedance for antenna type
indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that
type, are strictly prohibited for use with this device.
Manufacturer Model Connector Type Maximum Gain Impedance
INVAX System Technology Corp. AN2400-
9297SM
SMA Male 5.7 dBi 50 Ohm
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitationestautorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le brouillageest susceptible
d'encompromettre le fonctionnement.
When using the device, ensure that the antenna of the device is as least 20 cm away from all persons.
Hereby, SZ DJI TECHNOLOGY CO. LTD declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.