Caution, Assembly cautions, Usage cautions – DJI Lightbridge User Manual User Manual
Page 4
©2014 DJI. All Rights Reserved.
4
Caution
Aircraft in flight can cause serious damage or injury. Please fly safely at all times.
Assembly Cautions
(1)
Install antennas before powering on ground system or air system.
(2)
Point air system antennas downward when in use, do not twist or bend antennas. Avoid obstructing
antennas to ensure transmission quality.
(3)
Keep both ends of air system antennas as further as possible to achieve optimal transmission
performance. In addition, keep these antennas away from metals.
(4)
Use only DJI approved antennas and installed them correctly. Other antennas are incompatible.
(5)
Only 2.4GHz remote control can be connected to ground system of DJI LIGHTBRIDGE. Chose the
remote control with PPM trainer output.
(6)
2.4GHz remote controls must be connected to ground system for aircraft and gimbal control through
training ports. RF functions must be switched off.
(7)
Do not create shorts or open circuits when soldering.
(8)
Do not rotate gimbal if connected to camera HDMI port using DJI AV gimbal. This will cause gimbal
or HDMI cable damage.
(9)
Disconnect HDMI cable from the camera when powering on the DJI non-HD gimbal. Failure to do so
might damage HDMI cable.
(10) Keep HDMI cable away from on-board GPS module.
(11)
Do not modify DJI LIGHTBRIDGE.
Usage Cautions
(1)
Check that all connections are correct and firm before every use.
(2)
Check ground system battery capacity before every use. If the battery capacity is lower than 25%,
charge ground system. If ground system powers off, the air system will enter failsafe mode.
(3)
Check environment before every use to ensure no 2.4GHz device interference (e.g. other 2.4GHz
remote controls, Phantom 2 Visions).
(4)
Check remote control channels using DJI LIGHTBRIDGE Assistant before every use to ensure a good
connection and normal functionality.
(5)
The air system built-in receiver will go into failsafe mode if the remote control and ground system are
disconnected during use.
(6)
Turn smart device sound volume to maximum to hear alarms more clearly, e.g. bad remote control
signal and low aircraft battery capacity.