DJI Lightbridge User Manual - Manual (Page 25)

©2014 DJI. All Rights Reserved. 25
2.3.4 Phantom 2 Vision+ Mode
Scenario 9 – Phantom 2 Vision+ with DJI Lightbridge
To use Phantom 2 Vision+ with DJI Lightbridge, visit DJI WIKI page on DJI official website
( http://wiki.dji.com/en/index.php/Using_a_DJI_Phantom_2_Vision%2B_with_the_DJI_Lightbridge ) for details.
2.3.5 DIY Mode
Only HDMI and AV port is available for video transmission under DIY mode.
Scenario 10 – DIY mode
DIY users should select either HDMI or AV based on camera video output and follow the below connection
procedures:
1. On AV cameras, connect AV port to AV output with AV cable. On HDMI cameras, connect HDMI IN
port to the HDMI out with HDMI cable.
2. Connect Gimbal Port to onboard battery and CAN-bus port on DJI flight control system (CAN1 port
for DJI A2 users) via the supplied air system power and CAN cable.
3. Connect DBUS to DBUS port (X2 ports) on flight control system with DBUS cable.
4. Refer to flight control system manuals to complete connection.
The below example is based on DJI A2.
(3S ~ 6S)
X2
AV
HDMI
Devices on
CAN1 Bus
HDMI