Metrohm 857 Titrando - Manual (Page 25)

825 Lab Link, Instructions for Use 21
Under Connection status the following messages are possible:
“inactive” Ethernet connection is deactivated (no periodic
status test).
You can active the connection with the Connec-
tion active checkbox under Connection/Edit/Set-
tings.
“not available” No Ethernet connection to 825 Lab Link hardware
or the latter is switched off.
“connected” A functioning Ethernet connection exists to the
825 Lab Link hardware.
“busy” Data transfer Titrando-System ↔ Lab Link Server
software is taking place
Please note that the message given in column 3 only indicates
the status of the Ethernet connection from the 825 Lab Link
Server to the 825 Lab Link hardware. The connection from the
Lab Link Server to the Titrando system is checked by the Client
(Touch Control) for each communication.
3.2 Operation
When the Lab Link connection has been set up correctly and is
active then on the Touch Control you will have a further storage
medium available in addition to "Card 1" and "Card 2": the op-
tion "Shared memory".
Please note that, because of the limited transmission speed of
the RS 232 connection from the Titrando system to the 825 Lab
Link, this connection is not suitable for managing the stored files
with the Touch Control file manager. For this purpose, and for
viewing and e.g. recalculating determination data, the PC Control
program is optimally suited; this is supplied with each Titrando
system.