Metrohm 857 Titrando - Manual (Page 8)

2 Installation
4 825 Lab Link, Instructions for Use
2 Installation
2.1 Requirements
In order to network a Titrando system using the 825 Lab Link you
require the following equipment (see also Sections 4.3 and 4.5).
• Titrando system with Touch Control
• 825 Lab Link with 6.2134.040 RS 232 Cable
• 10 MBit network with RJ45 Ethernet cable
• One free IP address per 825 Lab Link; Subnet Mask and
Gateway must be known if applicable
• 6.2148.020 USB RS 232 Box with 6.2151.030 USB Cable
The 825 Lab Link Server software should be installed on a PC
with the following minimal equipment level:
• Processor: Pentium III
• Main memory: 128 MB RAM
• Free hard disk memory: 50 MB for program files and sufficient
space for the planned Titrando data
• Network connection with at least 10 MBit/s
The use of Microsoft Windows 2000 or Windows XP as the oper-
ating system is absolutely essential.
Warning! The installation of the 825 Lab Link Server must be car-
ried out as "Administrator". If you are using an NTFS file system
then take care that the users intending to utilize the server opera-
tion have full rights of access to the data folders that have to be
set and to all subfolders created in them. This can be checked in
Windows Explorer in the security settings in which the properties
of the corresponding folders are defined. Please note that for the
operation of the 825 Lab Link Server software the corresponding
user must remain continuously logged in under Windows.
Windows XP: The safety settings described above are only ac-
cessible when the option "Use simple file release" is switched off
in the menu Extras / File options / View in Windows Explorer.