Metrohm 940 Professional IC Vario TWO/SeS/PP - Manual (Page 18)

2.3 Feed-throughs for capillaries and cables
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
10 ￭￭￭￭￭￭￭￭
940 Professional IC Vario TWO/SeS (2.940.2400)
5 Vacuum connection
For connecting an Extension Module that
has a degasser but not its own vacuum
pump. This connection has to be firmly
sealed with a stopper when not in use. 6 Exhaust opening
Labeled Exhaust. For extracting the air from
the vacuum chamber.
7 PC connection socket
For connecting the instrument to the com-
puter with the USB cable (6.2151.020). 8 USB connection sockets
Labeled USB 1 and USB 2. For connecting
USB devices.
9 Transport locking screws
For securing the high-pressure pump (in the
middle plug-in) when transporting the
instrument. 10 Extension Module connection socket
Labeled Extension Module. For connecting
the cable (6.2156.060) used for connecting
the instrument to the Extension Module.
11 Transport locking screws
For securing the high-pressure pump (in the
bottom plug-in) when transporting the
instrument. These screws are only installed if
a plug-in with a high-pressure pump is used
in the bottom slot.
12 Base tray
With leak sensor and leak sensor cable.
13 Leak sensor connection socket
Labeled Leak Sensor. For connecting the
leak sensor connection cable coiled up in
the base tray.
14 MSB connection sockets
Labeled MSB 1 and MSB 2. For connecting
MSB devices.
15 Cooler
For cooling the power supply unit. May
become hot!
16 Power socket
Power socket for connecting the power
cable and power switch for switching the
instrument on and off.
17 Knurled screws
For fastening the removable back panel.
2.3 Feed-throughs for capillaries and cables
Multiple openings are available for leading capillaries into the instrument
and for leading capillaries and cables out of the instrument:
￭ Openings on the door (see Figure 3, page 11)
￭ Openings on the back panel
￭ Ducts between the instrument and the base tray as well as between
the instrument and the bottle holder (see Figure 5, page 13)