Metrohm 909 UV Digester - Manual (Page 22)

3.4 Preparing and connecting the temperature sensor
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
14 ￭￭￭￭￭￭￭￭
909 UV Digester
3.4 Preparing and connecting the temperature sensor
The temperature sensor (6.1110.010) is included in the scope of delivery
for the 909 UV Digester.
Preparing
Proceed as follows:
1 Remove the temperature sensor from the storage vessel.
Figure 10 Removing the temperature sensor from the storage ves-
sel
2 Remove the spacer in the lower part of the glass tube.
Figure 11 Removing the spacer from the temperature sensor
Keep the spacer in reach. It will have to be attached back on the
glass tube afterwards.
3 Remove the SGJ sleeve.
Figure 12 Removing the SGJ sleeve from the temperature sensor
4 Guide the thermometer plug (6.1446.190) over the temperature sen-
sor from the bottom until it is flush with the head of the temperature
sensor.