Metrohm 909 UV Digester - Manual (Page 32)

4.4 The display
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
24 ￭￭￭￭￭￭￭￭
909 UV Digester
Key Main dialog Parameters Lamp info Lamp setup
[ ▲] Increase the display's
contrast. Depending on the cur-
sor position:
￭ Go up one line.
￭ Page up by one
value list.
Go up one line. Depending on the cur-
sor position:
￭ Go up one line.
￭ Page up by one
value list.
[ ▼] Decrease the display's
contrast. Depending on the cur-
sor position:
￭ Go down one line.
￭ Page down by one
value list.
Go down one line. Depending on the cur-
sor position:
￭ Go down one line.
￭ Page down by one
value list.
[ ▶] – Depending on the cur-
sor position:
￭ Move the cursor to
the value range.
￭ Move the cursor
one position to the
right.
– Depending on the cur-
sor position:
￭ Move the cursor to
the value range.
￭ Move the cursor
one position to the
right.
[ ◀] – Depending on the cur-
sor position:
￭ Move the cursor to
the value range.
￭ Move the cursor
one position to the
left.
– Depending on the cur-
sor position:
￭ Move the cursor to
the value range.
￭ Move the cursor
one position to the
left.
4.4 The display
4.4.1 Display elements
T
1
2
3
4
Figure 21 Main dialog - Display elements
1 Radiating time
Shows the remaining radiating time since
the UV lamp was started. 2 Temperature display
Shows the current temperature measured in
the sample.
3 Temperature display
Shows the configured sample setpoint tem-
perature. 4 Status line
Contains the current status or an error mes-
sage along with the respective symbol.