Metrohm 887 Professional UV/VIS Detector - Manual (Page 18)

3.3 Mounting base tray and bottle holder (optional) ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
10 ￭￭￭￭￭￭￭￭ 887 Professional UV/VIS Detector
3.3 Mounting base tray and bottle holder (optional)
The 6.2061.110 base tray and 6.2061.100 bottle holder protect IC instru-
ments from dust, dirt and leaking fluids. If more than one instrument of
the Professional IC family is used, these can be set up in one or more
stacks. We recommend that a bottle holder and a base tray be mounted
on/below each stack of instruments.
Bottle holder and base tray must be removed or mounted every time one
of the following instruments is mounted on or under an 850 Professional
IC instrument:
￭ One or more 872 Extension Module.
￭ An 886 Professional Thermostat / Reactor.
￭ An 887 Professional UV/VIS Detector.
￭ or another instrument of the same support surface.
3.3.1 Removing / mounting the base tray
The base tray must be removed, in case you want to place another instru-
ment under the IC instrument. Proceed as follows: