6 connecting the flow-through cell, Connecting the flow-through cell, Figure 6 – Metrohm 887 Professional UV/VIS Detector User Manual
Page 27: Connecting detector input
■■■■■■■■■■■■■■■■■■■■■■
3 Installation
887 Professional UV/VIS Detector
■■■■■■■■
19
3.6
Connecting the flow-through cell
To connect the capillaries to the flow-through cell, proceed as follows:
Connecting the capillaries
1 Connecting detector input
■
Unscrew the pressure screw form the detector inlet IN.
■
Slide the pressure screw over the detector inlet capillary such that
a small part of the capillary is visible at the top.
■
Screw the detector inlet capillary to the detector inlet with the
pressure screw.
2
1
3
Figure 6
Connecting detector input
1
Detector inlet capillary
PEEK capillary (6.1831.100)
2
Detector inlet
Labeled with IN.
3
Pressure screw
2 Connecting detector output
■
Unscrew the pressure screw form the detector outlet OUT.
■
Slide the pressure screw over the detector inlet capillary such that
a small part of the capillary is visible at the top.
■
Screw the detector outlet capillary to the detector outlet with the
pressure screw.