BridgeWave AR60X - Manual (Page 28)

AR60X Installation Manual
580­00517, rev B 22
Figure 3.8.1­1: 60X Ice Shield
3.8.2 Optional Kit
The part number for this kit is 515­00529 (Available through Sales, see contact information section)
Refer to the table below for the kit required for your particular application. Each kit contains the
necessary materials for the installation of the ice shield on one radio. Two kits are required per link.
Qty: Description:
1 ea. Ice Shield Canopy
1 ea. Ice Shield Clamp, 6’
3.8.3 Installation Instructions
1. Remove the protective liner from the plastic canopy.
2. Use a screwdriver or 5/16” nut driver to set the hose clamp to the end of its range for
maximum opening.
3. Slip the hose clamp over the radome so that it loosely sits in approximately the middle of the
radome.
4. Slide one end of the plastic canopy under the clamp and slowly bend it around the canopy and
work it under the rest of the clamp.