Barco MatrixPRO HD/SD-SDI - Manual (Page 75)

MatrixPRO • 16x16 and 8x8 HD/SD-SDI Router • User’s Guide 65
_K==oÉãçíÉ=`зенкзд=mêçíçÅçä
MatrixPRO Remote Commands
j~íêáñmol=oÉãçíÉ=`згг~еЗл
The table below lists MatrixPRO remote commands. Click the hyperlink for detailed
descriptions and examples.
Table B-4. MatrixPRO Remote Commands
Command Description
HELP Capabilities. Send complete list of commands available in ASCII format
CLEAR Clear all matrix video routings
CSUMSTAT Display Main Code/RBF Checksum info
FPLOCK en Locks/unlocks Front Panel control
GADD grp out in Add an output or input to group
GCLEAR grp Clears grouping information
GDEL grp out in Remove output, input from group
IPCONFIG I3 I2 I1 I0 IP address configuration I3.I2.I1.I0
ISTAT num Input video status
LOADRMP Places unit into loader mode for firmware upgrade
OBLNK out blnk Displays output channel status
OSTAT Displays output status in ASCII
PRST num Saves current front panel configuration to a Preset location
PSTAT Displays preset status in ASCII
RCLKEN num en Enables/Disables individual output reclockers
RESETMP op Reset MatrixPRO, recall saved Flash values op [R|F] Reset|Factory Reset
RNOV Recall Flash settings
RPRST num Recall preset from a Preset location
RTEMP out in Route inputs to outputs. If output is in group, group is routed too
SBAUD mode Sets Baud Rate. 0=19200, 1=28800, 2=38400, 3=57600
SMODE mode [485id] Serial Mode. 0=RS232, 1=RS485. [485id] opt if RS232
SWITCH mode Switching Mode. 0 = (Vertical Interval Switching Off), 1 = On
TAKE en en = 1 simulates a TAKE button pushed on the front panel (i.e takes all preliminary
routes and makes them permanent). en = 0 simulates a CANCEL button pushed
UNOV Save current settings to FLASH