Sky-Watcher Multi-Purpose Computerized Mount - Manual (Page 5)

The AllView mount comes completely pre-assembled and can be operational in a matter of minutes. The mount is conveniently packaged
in one reusable shipping carton that contains all of the following accessories:
•
AllView mount
• SynScan hand control
• Mounting bracket (in 4 pieces)
• Steel tripod
• Tripod accessory tray
• Camera shutter cable (for most Canon Rebel cameras)
• RS-232 cable
Assembling the AllView™ Mount
Start by removing the AllView mount from its shipping carton and removing all of the accessories from their individual boxes.
Remember to save all of the containers so that they can be used to transport or store the mount.
Tripod and Mount Setup
The AllView mount is shipped with the tripod already attached. To set up the mount and tripod:
1.
Slowly loosen the height adjustment screws and gently pull out the lower section of each tripod leg. Tighten the screws to hold
the legs in place, as shown in Fig. 1.
2. Spread the tripod legs apart to stand the tripod and mount upright, as shown in Fig. 2.
Assembly
Fig. 1
3. Adjust the height of each tripod leg until the mount is properly leveled. There is a leveling bubble provided on the mount’s base
that you may use to check the mount’s leveling. Note: the tripod legs may not be at same length when the mount is leveled.
5
Fig. 2