Soleus GPS Draft (SG200) - Manual - Manual (Page 2)

GPS Draft – Instruction Manual
Step 2) Charging the Battery:
Charge the unit for at least 4 hours before first use. The length of time for a fully charged
battery will last depending on the actual usage. It is recommended to regularly re-charge your
battery every 1-2 months even if it is not used to maintain good battery condition.
2.1) Plug your USB PC link cable to your PC
2.2) Align the charging clip with the contacts on the back of the Bike GPS computer.
2.3) Connect the charging clip securely to the Bike GPS computer.
Note: Please thoroughly dry the charging contacts and surrounding area to ensure proper
electrical contact and prevent corrosion.
When the battery is low, it is time to charge the Bike GPS computer.
Battery low condition:
You cannot turn ON the GPS when the battery is low. The Bike GPS computer will display
LOW BATT. You need to recharge the battery in order to use the GPS again.
When the battery is almost low and you still perform your exercise, your data may not be
saved. Please make sure the battery have enough battery power before doing your exercise
in order not to lose your data.
Step 3) Configure your Bike GPS computer:
Before using your Bike GPS computer, please set your Bike computer.
3.1) Go to SET mode and set the following parameters: AUTO LAP, TIME, UNIT, USER,
NIGHT, Contrast, CHIME, ALARM, ODO, and VIEW.
3.2) TIME, NIGHT, CONTRAST, & CHIME, can also be set in TIME SET mode.
3.3) AUTO LAP, UNIT, USER, ODO, and VIEW can also be set in BIKE SET mode.
3.4) ALARM can also be set in ALARM SET mode.
Step 4) Acquire Satellite signals:
In order to get the correct time of day and begin using your Bike GPS computer, you have to
acquire the Satellite signals. It may take a few minutes to get the signals.
4.1) Go outside to an open area away from tall buildings and trees. Orient the GPS antenna
towards the sky for best reception. The antenna is located at the 12 o’clock position of
the Bike GPS computer.
4.2) Stand still and do not begin moving while locating the Satellites until the GPS signals are
already received.
4.3) How to Turn ON the GPS: Following are 3 the ways to turn on the GPS.
o While in Time mode, press S1 to turn ON the GPS. The Bike computer will display
the GPS / INDOOR selection screen. Press S1 to select GPS and press S5 to
confirm. The bike computer will start locating the satellites and go to Bike mode.
While the computer is searching satellite signals, press S5 to view the Battery level
and remaining memory.
o Press S7 repeatedly to enter BIKE or CHRONO mode. The Bike computer will
display GPS / INDOOR. Press S1 to select GPS and press S5 to confirm. If you
select INDOOR, you will have your exercise without GPS
o Press and hold S7 from any mode to turn ON the GPS
4.4) How to turn OFF the GPS:
o Press and hold S7 for 2 seconds will turn OFF the GPS. The computer will display
GPS OFF and then the INDOOR screen.
o When CHRONO is stopped or save, after 10 minutes the Bike computer will auto
return to Time view. GPS will be on standby for the hours, GPS ring icon blinks
during this time. After 1 hours, the GPS will be turned OFF and the GPS ring icon is
also OFF
.
GPS signals and its meaning:
You will hear a beep sound when the Bike computer has received a GPS signal or when the
GPS signal has been lost. LOST GPS signal will also be displayed in the screen.