Soleus GPS Draft (SG200) - Manual - Manual (Page 4)

GPS Draft – Instruction Manual
Setting the ODOMETER:
NOTE: You cannot set the Odometer if the chronograph is running. Stop & save your
exercise first before setting the Odometer.
•
Press S5 while ODO is blinking. The first digit will start to blink.
• Press S1/S11 to change the value.
• Press S5/S7 to set the next digit.
• Press S1/S11 to change the value.
• Repeat the process to set all the remaining digits.
Setting VIEW:
You can set the information displayed in Line 2 & Line 3 in BIKE mode in these setting
screens.
•
Press S5 while VIEW is blinking. The computer will display the VIEW / DIST / CHRO
screen and CHRO is blinking.
• Press S5 to toggle between Line 2 & Line 3 blinking.
• Press S1/S11 to change the information to display in that line. You can select any of
the following information to be displayed: Chrono, Distance, Calorie, ODO, & Clock.
• Press S7 to exit
5.2) Using Chronograph mode:
BIKE & CHRONO modes have the same chronograph counter. When the chronograph is
started or stopped in BIKE mode, the same thing happens in CHRONO mode.
5.2.1) Press S7 from BIKE mode to go to Chronograph mode. The Bike computer will
display GPS/ INDOOR.
5.2.2) Press S1/S11 to select between GPS and INDOOR.
5.2.3) Press S5 to confirm your selection.
o If you select GPS, the bike computer will start to search for GPS signal.
o If you select INDOOR, you will have your exercise with no GPS.
5.2.4) After searching for the GPS Satellite signal, the computer will automatically
display the remaining BATTERY power level, remaining DATA TRACK MEMORY
and then display the GPS GO screen.
5.2.5) Press S5 to change the information displayed in Line 2. You can select any of the
following information to display: Chrono, Distance, Calorie, ODO, & Clock.
5.2.6) Press S1 to START
5.2.7) Press S11 to take LAP. If auto lap function is set, the Bike computer will take lap
automatically based on auto lap setting in SET mode. There is also a beep sound
during taking an auto lap function. The Bike Computer will display the Lap number,
Lap time, and Split Time for 10 seconds and continue running.
5.2.8) Press S1 to stop after completing your exercise.
5.2.9) Press S5 while the chronograph is stopped to view your current data before
saving. Following are the information as you press S5:
o Distance / Chrono / Stop
o Chrono / ODO / calorie
o Calorie/ Ave Speed / Max Speed
5.2.10) Press S11 or press and hold S1 to save your data.
When the Chronograph is stopped and reset, if no activity for 15 minutes, the GPS will
automatically turn OFF and return to TIME mode.