Trebor Quantum Series Di Water Heater - Manual (Page 22)

PAGE 22 QUANTUM DI HEATER OPERATION / MAINTENANCE MANUAL
The current IP address and mask is displayed. Note that the field being
edited is displayed in red. Press the “Enter” button when done changing
the IP address or mask to apply the changes. Changes to the IP address
and mask will take effect immediately. Please note that the previous IP
address and mask will remain active in the system until power is cycled to
the heater.
Press the “Serial Comm” button to change serial communications
settings. Default settings are 9600, 8, E, 1.
Figure 12: Serial Communication Setup
Press the “Time/Date” to set the system time and date.
Figure 13: Changing System Date and Time
When changing the system date or the time, each field must be changed
and apply button pressed to update the system before changing the next
field. For instance, if the month and day fields need to be changed, select
the month field. Use the up and down arrows to select the correct month.
When done, press the “Apply” button before selecting the day field. Use
the up and down arrows to select the correct day and press the “Apply”
button to initiate that change. This also applies to the time. The hour,
minute and AM/PM field must be changed separately by changing the
field and pressing the
“Apply” button to apply that change.
Press the “View Logs” button to access the log reports described in
section 4.2.f.