Ultra-cut 400 xt – Tweco 400 XT Ultra-Cut Plasma Cutting System User Manual
Page 53
Advertising
ULTRA-CUT 400 XT
Manual 0-5275
INSTALLATION
3-31
Art # A-12059
Lower screws
(2 per side)
Upper screws (2 per side)
Cover
Ground Wire
3. The Arc Starter must be grounded; the grounding terminal is marked . Refer to the previous section for grounding
details.
Ground Cable
Art # A-04758
1 Nut and 1 Washer
Remain in Place
Torch Leads
4. Use a clamp to secure the Torch Lead Shield braid brass ring to the port on the Remote Arc Starter as shown.
Advertising