Ultra-cut 400 xt – Tweco 400 XT Ultra-Cut Plasma Cutting System User Manual
Page 57
Advertising
ULTRA-CUT 400 XT
Manual 0-5275
INSTALLATION
3-35
3. Connect the gas supply lines and the control cable connector from the Gas Control Module to the Valve Kit as shown. Hold
the check valves stationary while attaching the gas lines.
Control Cable
Plasma Gas Inlet
Shield Gas Inlet
Preflow Gas Inlet
WMS™ Inlet
Art # A-07646
Exhaust Muffler
CAUTION
Hold all fittings stationary while attaching hoses or leaks can be created. Side pressure can break the check valves
or weaken their connection to the torch valve assembly. All fittings must be checked for leaks after assembly.
Advertising