Weller WR2 - Manual (Page 37)

WR 2 17-20
DE
EN
FR
IT
ES
PT
NL
SV
DK
FI
GR
TR
CZ
PL
HU
SK
SL
EE
LV
LT
Resetting calibration to factory settings
1. Select the menu item FCC in Menu 2.
2. Press and hold down button ┌ 2 ┐.
3. Then press the UP and DOWN buttons simultaneously.
"FSE (Factory Setting Enabled) appears on the display.
The repair station is now reset to the factory calibration.
4. Change to the next menu option using the ┌ 1 ┐ (back) or ┌1·2 ┐
(forwards) button.
Deactivating / activating automatic channel changing
This function can be used to deactivate automatic channel changing
(activated at the factory):
1. Select the menu item AUTO CHANNEL in Menu 2.
2. Set the status with the UP or DOWN button.
(ON = activate / OFF = deactivate)
3. Change to the next menu option using the ┌ 1 ┐ (back) or ┌1·2┐
(forwards) button.
Activating / deactivating the special button (10)
The special button (10) (deactivated at the factory) can be activated
using the SP Button function:
1. Select the menu item SP BUTTON in Menu 2.
2. Set the status with the UP or DOWN button
(ON = activate / OFF = deactivate).
3. Change to the next menu option using the ┌ 1 ┐ (back) or ┌1·2┐
(forwards) button.
After activating the special button (10), it can be used as a shortcut
back to Menu 1. The function previously selected is saved when the
menu is exited with the special button (10).
Activating / deactivating the ECO button (8)
The ECO button (deactivated at the factory) can be activated using
the ECO function:
1. Select the menu item ECO in Menu 2.
2. Set the status with the UP or DOWN button
(ON = activate / OFF = deactivate).
3. Change to the next menu option using the ┌ 1 ┐ (back) or ┌1·2┐
(forwards) button.
After activating the ECO button (8), it can be used to set all 3
channels to Standby mode. The green LED (9) lights up and the
channels are set to the set standby temperature.
If a switching holder is in use, the function is reset when the tool is
removed from the holder.