ClearOne Converge Pro - Manual (Page 79)

74
SELECT MENU ESC TELCO ON / OFF
-30 -10 -4 0 +4 +8 +12 METER 1 2 3 4 TX RX TELCO
CONVERGE PRO 840T
SELECT MENU ESC TELCO ON / OFF
-30 -10 -4 0 +4 +8 +12 METER 1 2 3 4 TX RX TELCO
CONVERGE PRO 840T
SELECT MENU ESC TELCO ON / OFF
-30 -10 -4 0 +4 +8 +12 METER TX RX TELCO
CONVERGE PRO TH20
SELECT MENU ESC
-30 -10 -4 0 +4 +8 +12 METER 1 2 3 4 5 6 7 8 TELCO
CONVERGE PRO 880
SELECT MENU ESC
-30 -10 -4 0 +4 +8 +12 METER 1 2 3 4 5 6 7 8 TELCO
CONVERGE PRO 880
Slave
Slave
Master
Slave
Master
Converge Pro 840T
Converge Pro TH20
Link Out
Link In
Link Out
Link In
Link Out
Link In
Link Out
Link In
Audio flow is stopped
RS-232
control
device
Converge Pro 880
Converge Pro 880
Converge Pro 840T
X
Audio flow is stopped X
This prevents audio from being received from units above the master unit in a site. For example, you can configure
a site with multiple units for a room-combining application where all units act together when three smaller rooms are
combined into a larger room. When the rooms are divided again, the audio from one room will not be available in
the other two rooms due to the Audio Master configuration.
In graphic above, the third unit in the network is an Audio Master with an RS-232 control device attached. Audio
from the first and second units in the network does not pass beyond the second unit. Likewise the second Audio
Master unit in the network does not pass audio from the unit before it. Sites can use multiple RS-232 devices, which
you can connect to any unit regardless of Control Slave or Master designations.
Serial control is not affected by Audio Master or Slave designations. Global serial control of the site is maintained by
the unit connected to a control device through its RS-232 port, in this case the third unit in the stack, which is also
designated as the first Audio Master in the network.