ClearOne Converge Pro - Manual (Page 81)

76
IP Filters
Use IP Filters to enter specific IP addresses that will be allowed to connect to the selected unit. You can specify
a range of IP addresses by using zeros. For example, entering 192.168.105.0 will allow any IP addresses in the
192.168.105.1 to 192.168.105.254 range to access the unit.
Serial Port Settings
Select the Serial Port settings (Baud Rate and Flow Control) that are appropriate for your installation. Serial
Echo enables and disables echo on the serial port. The default for Baud Rate is 57600. The default for Flow
Control is Hardware. The default for Serial Echo is On.
When you are finished configuring unit properties, click OK to save the changes, or Cancel to close the Unit
Properties window.
AMX Duet Mode
Sets a beacon to signify the device is AMX compatible and looks for new or updated modules on the AMX Web
Site. If new or updated modules are available, the user will be prompted to download the module.
CONVERGE PRO VH20 UNIT PROPERTIES
Unit Properties for the CONVERGE Pro VH20 are accessed identically to any other CONVERGE unit. However,
once the Properties,
SIP Properties window has launched, several new configuration features are available.
NOTE: The SIP Properties window is also accessible by right-clicking the VH20 icon under
Site View and selecting SIP Properties.
Five tabs contain most of the configuration settings required to customize the CONVERGE Pro VH20. Do not
modify these settings unless you have in-depth knowledge of VoIP, SIP and Network functions, setup and