Great Plains TCN5313 Assembly Manual - Manual (Page 11)

03/17/2014 566-170Q-ENG
Great Plains Manufacturing, Inc. 7
Assembly
Torque Tube
Refer to Figure 5
11. Once the center Frame has been uncrated, carefully
turn the center frame upside down and set on blocks
to assemble torque tube.
12. Carefully raise the torque tube with an overhead
hoist and secure with 1 1/4 x 7 pins , 3/8 x 2 1/4 Gr.
8 special thread and 3/8 top lock nut.
13. Install pre-assembled hub assembly or brake hub
(LH and RH, on outside spindle locations) assembly
(if machine is equipped with brakes) using the 1 x
4 5/8 pin and secure with 3/8 x 2 roll pin.
14. Attach the tire/wheel assembly to hub assembly
and secure with 5/8 lug nuts .
15. All bolts may be tightened to specs, See “Torque
Values Chart” on page 27.
Center Lift & Gang Mount
Refer to Figure 6
16. Carefully raise center frame up from front bar and
turn over and set on stands.
17. Attach the cylinder mount bars and lift link to
center frame using 1 x 3 1/2 hex bolts , 1 x 4 hex
bolts and lock nuts.
18. Now install 4 x 10 x 1.38 cylinders using 1 x 3 1/8
pins , 1.5 x 1.0 x.075 machine washers and 3/16 x
2 cotter pins.
19. Install cylinder transport locks to cylinders using
the 5/16 wire retainer pin.
20. Attach center gang mount to front of center frame
with 3/4 x 2 hex bolts , 3/4 lock washers and 3/4
nuts.
Note: Store extra shims on back side of end plate fac-
ing down with same bolts that hold rest of shims.
21. Install shims with 3/8 x 1 1/4 hex bolts , 3/8 lock
washers and 3/8 nuts.
22. All bolts may be tightened to specs, See “Torque
Values Chart” on page 27.
Figure 5
Torque Tube
42006
2
6
3
4
1
U
D
F
B
L
R
4
5
7
1
2
3
4
5
6 4
7
Figure 6
Center Lift & Gang Mount
42007
8
2
3
9
1
U
D
F
B
L
R
6
7
5
4
11
10
10
1 2
3
4
5
6
7 5
8
9
10
11
10 11