Great Plains TCN5313 Assembly Manual - Manual (Page 16)

12 TCN5107-5313 Great Plains Manufacturing, Inc.
566-170Q-ENG 03/17/2014
569-190S Shank
Note: See machine layouts in Appendix for proper shank
placement. The front and rear shank mount assem-
blies will be shipped pre assembled from factory in
two parts in boxes. There will be the mount assem-
bly and the shank assembly.
Refer to Figure 10
59. Install the mount assembly
to the rear side of
tubes. Install front mount bracket on front of tubes,
align holes, secure with 3/4 x 2 1/2 hex bolts , 3/4
lock washers and 3/4 nuts. Slide these two parts
over frame tube in proper location.
60. Attach the shank assembly with 3/4 x 4 hex bolts
, 3/4 lock washers and 3/4 nuts.
61. Tighten all bolts to specs, See “Torque Values
Chart” on page 27.
569-196S Shank
Refer to Figure 11
62. Install the mount assembly
to the rear side of
tubes. Install front mount bracket on front of tubes,
align holes, secure with 3/4 x 2 1/2 hex bolts , 3/4
lock washers and 3/4 nuts. Slide these two parts
over frame tube in proper location.
63. Attach the shank assembly with 5/8 x 4 1/2 hex
bolt , 5/8 lock washer and 5/8 nut (rear hole), 1/2 x
3 hex bolt , 1/2 lock washer and 1/2 nut (front
hole).
64. Tighten all bolts to specs, See “Torque Values
Chart” on page 27.
Figure 10
569-190S Shank
42011
2
5
3
4
1
1
2
3
4
5
Figure 11
596-196S Shank
41668
1
3
4
2
5
6
1
2
3
4
5
5