Great Plains TCN5313 Assembly Manual - Manual (Page 22)

18 TCN5107-5313 Great Plains Manufacturing, Inc.
566-170Q-ENG 03/17/2014
Refer to Figure 21
North American Light Assembly
99. Fasten light bracket LH to center frame with 1/2 x
4 1/32 x 7 1/4 u-bolts , 1/2 lock washers and 1/2
huts. Repeat same procedure for light bracket RH .
100.Attach light mounting brackets to back side tube,
of center frame, with 1/2 x 6 1/32 x 5 1/4 u-bolts , 1/
2 lock washers and 1/2 huts.
101.Attach smv post to top side of same tube as light
mounting brackets , as close to center as possible.
Secure with 1/2 x 4 1/32 x 7 1/4 u-bolts , 1/2 lock
washers and 1/2 huts. Attach smv sign to back
side of smv post , secure with 1/4 x 3/4 pan head
screws , 1/4 lock washers and 1/4 nuts.
102.Route light harness 30’ lead from front of hitch
(tractor plug to front), along same route as hydraulic
hose (fasten in same clamps and hose wraps as
hoses). Plug one end of enhance light module
to
small end of light harness 30’ lead . Plug bigger
end of wishbone light harness into other end of
enhance light module . Route other ends over
towards (marked left and right) the light mounting
brackets as shown.
103.Mount red lamp lights to top of light mounting
brackets , with 1/4 x 1 1/4 hex bolts and 1/4 lock
nuts.
104.Mount amber lamp lights to top of light brackets
and , with 1/4 x 1 1/4 hex bolts and 1/4 lock
nuts.
105.Tighten all bolts to specs, See “Torque Values
Chart” on page 27. Be sure and get all wiring har-
nesses fastened up securely with hose wraps or
clamps (if routed close to hydraulic hoses) or use
cable ties
.
1
3
2
4
5
6
4
3
7
6
8
9
10
9
11
10
12
4 14
13
1 2 14
15