Wings – Great Plains TCN5313 Assembly Manual User Manual
Page 14
10
TCN5107-5313
Great Plains Manufacturing, Inc.
566-170Q-ENG
03/17/2014
Refer to Figure 9
Wings
41. Carefully align holes in wing frame LH and RH
with holes on center frame hinges. Secure with 1 3/4
x 8 5/8 pins
, 1/2 x 3 1/2 hex bolts
and 1/2 top
lock nuts.
Note: Be sure hole in pin and hole in collar on wing
frame are aligned and bolt goes through both of
them.
42. Attach wing stop
to center frame with 5/8 x 1 1/2
hex bolts
, 5/8 lock washers and 5/8 nuts.
43. Install center fold bracket
to center frame with 3/4
x 2 1/2 hex bolts
, 3/4 lock washers and 3/4 nuts.
44. Attach rebound valve plate
with 3/4 x 2 1/2 hex
bolts
, 3/4 lock washers and 3/4 nuts.
45. Install rebound valve
with 5/16 x 4 hex bolt
5/16
lock washer and 5/16 hex nut.
46. Attach double tee block
with 5/16 x 3 1/2 hex bolts
, 5/16 lock washer and 5/16 hex nut.
47. Attach wing shank mount
(model 5313 only),
secure with 3/4 x 2 1/2 hex bolts
, 3/4 lock washers
and 3/4 nuts.
48. Align holes in link
, rod end of 5 x 16 x 1.5 cylinder
and double fold link
, secure with 1 1/4 x 9 spe-
cial thread hex bolts
and 1 1/4 top lock nuts.
49. Secure other end of link
to front wing hinge lower
hole with 1 1/4 x 3 5/8 pin
, 1.88 x 1.25 x 10 ga
machine washer and 3/16 x 2 cotter pins.
50. Secure base end of cylinder
with 1 x 3 1/8 pins
, 1.5 x 1.0 x.075 machine washers and 3/16 x 2
cotter pins.
51. Mount wing gang mount (models 5311-5313)
to
front wing plates with 3/4 x 2 hex bolts
, 3/4 lock
washers and 3/4 hex nuts.
52. Tighten all bolts to specs, See “Torque Values
53. See “Valve, Fitting and Hose Assembly” on
page 14 for proper fitting assembly,
54. Turn elbow
into rod end of fold cylinder
.
55. Thread 3/4morb-3/4fjic adaptor
onto elbow
.
56. Thread two way valve
onto adaptor
.
57. Thread 3/4morb-3/4mjic adaptor
into two way
valve
.
58. See “Fittings Torque Values” on page 28 for proper
torque value.
1
2
3
4
5
6
7
8
7
9
10
11
12
13
7
14
15
16
17
14
21
15
18
19
20
22
15
23
22
24
23
23
24