Valve, fitting and hose assembly, Depth stop, Install rebound valve and o-ring fittings – Great Plains TCN5313 Assembly Manual User Manual
Page 18: See “ valve, fitting and hose assembly ” on
14
TCN5107-5313
Great Plains Manufacturing, Inc.
566-170Q-ENG
03/17/2014
Valve, Fitting and Hose Assembly
Refer to Figure 14
Depth Stop
75. Align holes in depth control valve
to top of depth stop
valve mounting bracket using 5/16 x 2 hex bolts
and 5/
16 lock washers.
76. Slide one end of (with 2 holes) depth stop tube
through slotted hole in depth stop valve mounting
bracket. Slide other end of depth stop tube
over lever
on torque tube, secure with 1/2 x 3 hex bolt
, 1/2 lock
washer and 1/2 nut.
77. Bolt depth stop screw assembly
to front of depth stop
tube
with 1/2 x 2 1/2 hex bolts
, 1/2 lock washers and
1/2 nuts.
78. Tighten all u-bolts to specs, See “Torque Values Chart”
Note: Install all hydraulic fittings as shown in steps below. See
hydraulic layouts in Appendix for proper hose routing.
Install Rebound Valve and O-Ring Fittings
79. Thread straight (non- adjustable stud) fittings
into
ports V1, V2 and C2 of rebound valve
.
Note: Tighten as shown below. Do not over tighten as this
could cause damage to valves.
a.
Inspect all components for damage or contamination dur-
ing shipping.
b.
Lubricate o-ring and threads on fitting.
c.
Turn fitting into port until finger tight, See “Fittings
Torque Values” on page 28.
80. Thread elbow (adjustable stud) fitting
into port C1 of
rebound valve
.
a.
Follow steps a and b from the foregoing instructions, then
proceed with the following steps below.
b.Looking from fitting from end with nut/washer/o-ring
assembly, turn nut clockwise as far as possible.
a.
Using wrench, turn fitting into port until the washer
touches the port spot face. Continue turning fitting until
washer touches thread nearest wrench pad.
81. Back off fitting counterclockwise not exceeding one revo-
lution until it is oriented in the correct position.
82. Place wrench on the wrench pad of fitting to keep fitting
from turning, See “Fittings Torque Values” on page 28.
Figure 14
Depth Stop
42017
U
D
F
B
L
R
2
1
6
4
5
3
1
2
3
3
4
5
3
6
Figure 15
Rebound Valve Fittings
41580
U
D
F
B
L
R
2
1
3
3
1
2
1