Cambridge Audio Multi-room speaker system - Manual (Page 18)

18 Incognito multi-room
AS10 / SS10 in-cceiling sspeakers
Standard installation would specify AS10/SS10 ceiling mounted
speakers which are matched to the Incognito system for optimum
audio performance. However, virtually any customer-specified
speaker units may be used.
Where ceiling or wall-mounted speakers are used, care should be
taken to ensure that all building regulations are followed.
When mounting speakers flush to a ceiling or wall, ensure that
enough depth/clearance is available in the respective cavity. A
clearance of at least 80 mm is necessary when mounting pairs of
AS10/SS10 speakers.
When deciding upon a ceiling or wall placement, care should be
taken to avoid joists, load bearing beams etc.
Before cutting ceiling loudspeaker holes it is suggested that the
area is tested for clearance by making an L- shaped probe from
strong wire (eg a coat hanger), drilling a small hole in the target area,
inserting the probe and slowly turning. Any obstructions will be
immediately obvious, so that the target area can be moved to a
more suitable position.
Also, locate loudspeakers taking into account location of furnishings
for optimal stereo reproduction.
Full details of installation, connection, operation and special
features can be found in the guide that accompanies the speakers.
L-shaped probe used
to check available void
space before cutting
speaker holes
AS10/SS10
207mm diameter
mounting hole